Installation Guide

11/1/20132
5. Fasten the white fixture lead to the white wire in the outlet box.
Fasten the wires together with an approved fastener (wire nut). Starting about 1' below the fastener, tightly wrap
the connection with electrical tape so that the connection seals the end of the fastener.
WARNING
Make sure that there is no exposed wire or strands that
could cause a dangerous short circuit !
6. Connect the black fixture lead to the black wire in the outlet box. Fasten the joined wires as in step 5.
7. Using the end nuts, loosely fasten the fixture to the outlet box.
Rotate and align the canopy as necessary.
Tighten the end nuts.
8. Install the lamps ( light bulbs).
NOTE: This fixture is rated for a 100 watt type A lamp.
WARNING
DO NOT EXCEED RECOMMENDED WATTAGE!
9. Place the glass into the cage.
Using the wing screws and sealing washers reassemble the cage to the roof.
10. Restore power to circuit at breaker or fuse box.
electrical tape
approved fastener
(
wire nut
)
Stem