Manual

ASSEMBLY
Your generator requires attachment of the negative battery
cable and is ready for useafter it has been properly
serviced with the recommended oil and fuel.
If you have any problems with the assembly of your
generator, please call the generator helpline at
1-888-61 1-6708.
ll_ _r_;.m_ I_T_I_
Remove Generator From Carton
I. Set carton on a rigid fiat surfacewith "This Side Up"
arrows pointing upward.
2. Carefully open top flapsof shipping carton.
3. Cut down corners of carton from top to bottom and
laythat side of carton down fiat.
4. Remove all packing material, carton fillers,etc.
5. Roll generator out of shipping carton.
Attach Negative Battery Cable
The sealed battery on the generator isfully chargedand
pre-installed except for the negative (black) battery cable.
You will need a I/2" or 13mm wrench to installthe
negative battery cable.
To install:
I. Cut off tie wrap securing loose end of negative (black)
cable.
2. Attach negative battery cable with 5/16" x 3/4" screw
and lockwasher to the engine block, next to the
starter (Figure I).Tighten securely.
Screw Washer
Positive
battery
cable
Negative
battery
cable