Manual
Section 3: Assembly
Attach Handle
You will need two I/2" or 13 mm wrenches to attach the
handle.
I. Attach handleto right side of generator frame (viewing
unit from front), as shown in Figure 2, with a 60 mm
capscrew,flat washers,nylon washers, and locknut.
60ram Capscrew
Nut
_Washer
J and o Braeket
_=_Nylon Washer
M
_ylon Washer
_ \ _ HandleBracket
/y\ _ Washer
60ram Capscrew
HandlePin
NOTE: DO NOT overtighten. Handle must be able to
move up and down freely.
2. Raisehandle and insert handle pin to move generator.
BEFORE STARTING THE
ENGINE
Add Engine Oil and Fuel
• Place generator on a level surface.
CAUTION
• Refer to engine manualfor oil and fuel fill information.
• Damage to equipment resulting from failure to follow this
instructionwill void warranty.
• Refer to engine owner's manual and follow oil and fuel
recommendations and instructions.
_ WARNING
Replace "1-I/2" with "2-I/4" fuel fill level given in engine manual.
Failure to follow this instruction may cause fuel to overexpand
and spill from tank.
NOTE: Check oil often during engine break-in. Refer to
engine owner's manual for recommendations.
NOTE: The generator assembly rotates on a prelubricated
and sealed ball bearing that requires no additional
lubrication for the life of the bearing.