Manual

Troubleshooting

TROU BLESHOOT| NG

Problem

No AC output is available, but

generator is running.

Cause

I. Circuit breaker is open.

2. Fault in generator.

3. Poor connection or defective cord

set.

Connected device is bad.

Correction

I. Reset circuit breaker.

2. ContactAuthorized service facility.

3. Check and repair.

4. 4. Connect another device that is in

good condition.

Generator runs good at no-load I. Short circuit in a connected load. I. Disconnect shorted electrical load.

but "bogs" down" when loads are 2. Generator is overloaded. 2. See "Don't Overload Generator".

connected. 3. Shorted generator circuit. 3. ContactAuthorized service facility.

Generator will not start; or starts Low oil level. Fill crankcase to proper level or place

and runs rough, generator on level surface.

I. Out of gasoline. I. Fill fuel tank.

Generator shuts down during

operation. 2. Low oil level. 2. Fill crankcase to proper level or

place generator on level surface.

Generator lacks power. Load is too high. See "Don't Overload Generator".