Datasheet

1. Scope:
This specification for approval relates to Metal Oxide Film Fixed Resistors
2. Type designation:
The type designation shall be in the following form :
(Ex.) MOR 1W-S J
˄˃Ө
Type Power Rating Resistance Nominal
Resistance
3. Ratings:
Ratings shall be shown in the table 1.
Table 1
Type
Rated Power
Max. Working Voltage
Max. Overload Voltage
Dielectric Withstanding Voltage
Rated Ambient Temp.
Operating Temp.Range
Resistance Tolerance
Resistance Range
3.1 Power rating:
Resistors shall have a power rating based on continuous full load operation at an
ambient temperature of 70 к. For temperature in excess of 70 к , the load shall be
derated as shown in the figure 1.
3.2 Voltage rating:
Resistors shall have a rated direct-current (DC) continuous working voltage or an approximate
sine-wave root-mean-square (RMS) alternating-current (AC) continuous working voltage at commercial-
line frequency and waveform curresponding to the power rating , as determined from the
following formula :
RCWV =
ЅP x R
Were : RCWV = Rated DC or RMS AC continuous working voltage at commercial-line frequency and
waveform (volt)
P = Power Rating (watt)
R = Nominal Resistance (ohm)
70 к
-55к --- +130к
± 5 %
1 ~ 50K
350 V
600 V
350 V
MOR
1W at 70к
Tolerance
All part numbers in the coding below start with "TC-" and end with "203"
Distributed by Conrad Electronic SE • Klaus-Conrad-Str. 1 • D-92240 Hirschau
Datasheet
V1_0717_01_en
1

Summary of content (10 pages)