Product Manual

............ www.truemfg.com ............
True Food Service Equipment, Inc.
28
28
REQUIRED TOOLS
•Phillips-HeadScrewdriver
CAUTION
Do NOT remove the gaskets on radius front,
(”RF”), coolers.
___________ STEP 1 ____________
Opencoolerdoorandremovemagneticdoor
gasket, (again, do not remove gaskets on
radius front coolers), along the side of door
oppositethehingebypullingthegasketoutof
theblackplasticretainerextrusion.Thiswill
exposethetwomountingholesforthescrew
whichsecuresthehandle.
___________ STEP 2 ____________
Remove contour bottle handle from its
protectivepackagingandremovethetwolong
screws from the back surface of the handle.
Remove the plastic spacers from the screws
andretainforuselater.
___________ STEP 3 ____________
Pushthescrewfromtherearsideoftheswing
doorbackthroughthebottomhole.Placeone
3/4”longspaceronthescrewandfastenthe
screwtothebottomholeincontourhandle.
Donotovertightenthescrew.
NOTE
Three hole configuration on contour handle
accommodates different size coolers.
Use only the two holes that match your
coolers door frame.
___________ STEP 4 ____________
Push theotherscrew throughthe nexthole.
Place the other 3/4” long spacers on the
screwsandfastentothehandle.Tightenboth
screws so the handle is secure but do not
overtighten.
___________ STEP 5 ____________
Replacethemagneticgasketintheretainer
extrusion.
INSTALLATION / OPERATION INSTRUCTIONS
IMPORTANT
Before installing lamp cover turn cabinet on
and allow it to reach
temperature.
___________ STEP 1 ____________
Locate rubber gasket behind lamp holder
mountedtoevaporatorhousing.
(SeeImage1).
___________ STEP 2 ____________
Fitthebottomedgeofthelampcoverintothe
bottomgrooveoftherubbergasketandrotate
upwardswhileworkingtheedgesintotherest
of the rectangular groove. (See Images 2-3).
(slidefingersunderneathtopedgesofrubber
gasketandpushrubberoverthetoplipofthe
lampshield).
___________ STEP 3 ____________
Besurelampcoverisseatedproperlyinrub-
bergasket.
NOTE
If cabinet is turned off and
interior allowed to warm up lamp cover may
become loose and require reinstallation. Follow
directions above.
Light Cover Installation for GDM-10F & GDM-12F
Lamp Cover
Rubber
Gasket
Lamp
Holder
1
2
3
Contour Bottle Handle Installation
(Specific Accounts Only)