Product Manual

............ www.truemfg.com ............
True Food Service Equipment, Inc.
29
29
MAINTENANCE, CARE & CLEANING
REQUIRED TOOLS:
•PhillipsScrewdriver
•StiffBristleBrush
•AdjustableWrench
•AirTankorCO2Tank
•VacuumCleaner
___________ STEP 1 ____________
Disconnectpowertounit.
___________ STEP 2 ____________
SLIDEDOORMODELS:(SeeImage1)
Take off lower grill assembly by removing two (2) screws in
lowercorners.(older modelsmayhavesnaplocktabsinsteadof
screws).
Loosen screws holding the top pivot pins. Swing grill up and
removeframehooksfrompivotpinsattopoflouver.
SWINGDOORMODELS:(SeeImage2)
Take off lower grill assembly by removing four (4) screws. See
images3&4.
___________ STEP 3 ____________
Removeboltsanchoringcompressorassemblytoframerailsand
carefullyslideout.(tubeconnectionsareflexible).
___________ STEP 4 ____________
Cleanoffaccumulateddirtfromthecondensercoilandthefan
withastiffbristlebrush.
___________ STEP 5 ____________
Liftcardboardcoverabovefanatplasticplugsandcarefullyclean
condensercoilandfanblades.
 ___________ STEP 6 ____________
INDOORLOCATION:
Afterbrushingcondensercoilvacuumdirtfromcoil,andinterior
floor.(SeeIllustration3).
OUTDOORLOCATION:
(GDM-33,GDM-47,andGDM-49only)Afterbrushing
condensercoilblowCO2throughcondenserfromfinsideto
fan.(SeeIllustration4.)
___________ STEP 7 ____________
Replacecardboardcover.Carefullyslidecompressorassembly
backintopositionandreplacebolts.
___________ STEP 8 ____________
Reinstalllouverassemblyontounitwithappropriatefastenerand
clips.Tightenallscrews.
___________ STEP 9 ____________
Connectunittopowerandchecktoseeifcompressorisrunning.
MAINTENANCE, CARE & CLEANING
CLEANING THE CONDENSER COIL
When using electrical appliances, basic safety precautions should be followed, including the following:
Slide Door Models
Swing Door Models
Loosen but do not remove 4 Phillips
screws inside the grill frame.
Lift the grill up until it clears the
screw key hole slots.
Illustration 3.
Illustration 4.
1
2
3
4