User Manual

- VOL: …as in Volume.
- BASS: You guessed it… this controls the bass level.
- CLEAN MIX: This is a single-knob mixer to allow you to mix clean signal with
overdrive signal. Fully counter-clockwise is 100% clean with no overdrive, fully
clockwise is 100% overdriven. In between… that’s where the magic is.
Internal Buffer On/Off: If you remove the bottom cover of the pedal, you will see a slide
switch for each channel which allows you to turn on/off the Pure Tone buffer circuit. We
recommend that you leave the first channel buffer on. However, if you want strictly true
bypass switching, you may turn both switches off.
Internal Noise Gate On/Off: There is a mini slide switch to turn the Distortion channel
noise gate on or off, inside the pedal, next to the Distortion footswitch. Just remove the
bottom cover of the pedal to see it.
Battery: You can use a battery, but… WHY? Use a 1 SPOT! If you must use a battery, please
remember to unplug BOTH In and Out when not using the pedal to conserve battery life.
IN and OUT:
Unlike previous versions of Jekyll & Hyde, the V3 version is really 2 pedals in 1 box. No,
seriously, it even has separate in’s and out’s if you want to use them. Check it out…
Normal
IN
OUT
IN
#1
OUT #1
IN #2
OUT #2
Change
Order
IN
Distortion
OUT
Overdrive
OUT
Distortion
IN
Overdrive
Separate
Pedals
For demos, warranty registration and assistance, please go to:
www.Truetone.com
2015