Owner manual

ManualsBrandsTuffy Security ManualsCar103

Page 1 of 5 - 6/4/2008 – Rev122006

INSTALLATION INSTRUCTIONS

Single Compartment Overhead Console #103

Please read and fill out the enclosed warranty registration card to activate your warranty.

Shipment Contents

103 Loop Bracket Footman Loop Bracket Electronics Support Frame Adjustable Support Bracket

(For wranglers 03+) (For wranglers 01-02)

Lower Adjustment Piece Upper Adjustment Piece Main Console Body

Shipping Package

(4)6-32 Flathead Phillips (2)6-32 Unslotted Screws (2)10-32 Panhead Phillips

(2)10-32 Flat Phillips (3)10-32 Button head Screws (2)1/4-20x3/8 SocketHead Screws

(3)3/16” Washers (2)1/4” Washers (4)5/16” Washers (2)5/16” Barrel Nuts

Summary of content (5 pages)

PAGE 1
INSTALLATION INSTRUCTIONS Single Compartment Overhead Console #103 Please read and fill out the enclosed warranty registration card to activate your warranty.
PAGE 2
Shipping Package (Continued) (2)10-32 Lock Nuts (4) 5/16” Lock Nuts (2) 5/16” U-Bolts (2) 1” Diaphragm Grommets (2)5/16-18x3” Carriage Bolts Rubber Seal TOOLS NEEDED • • • • • • • 1/8” Allen Wrench 3/16” Allen Wrench (Wranglers Pre 2003 without full roll cage only) T-20 Torx Driver (Wranglers Pre 2001 only) Small Phillips Screw Driver 5mm Allen Wrench ¼” Socket ½” Socket and Ratchet – Extensions and Swivels are helpful (Vehicles with Roll Cage only) PLEASE READ ALL INSTRUCTIONS THOROUGHLY BEFORE ST
PAGE 3
1. 2. Apply the Rubber Seal provided to the lid so that it will seal up against the console when closed. Check the lock operation. Route the wires for your stereo, CB, or speaker up along the roll bar and leave plenty of extra wire. Stock Jeep Wranglers 2000 or earlier 3. Remove the footman loop from the top center of the windshield frame using a T-20 torx wrench. Save all hardware. 4.
PAGE 4
Vehicles with a full roll cage 14. Carefully rotate the console up until you can use the (2)5/16” U-Bolts, (4)5/16” Washers, and (4) 5/16” Locknuts to bolt the console to the front roll bar. 15. Use (2)10-32x1 Button Head Screws and (2)3/16” Washers to bolt the rear assembly to the main console. There are nuts in the top of the console that these screws will go into. Do not over tighten. Over tightening will cause the top of the console to warp down. See Figure 7.
PAGE 5
Page 5 of 5 - 6/4/2008 – Rev122006