Owner manual

Page 4 of 5 - 6/4/2008 – Rev122006
Vehicles with a full roll cage
14. Carefully rotate the console up until you can use the (2)5/16” U-Bolts, (4)5/16” Washers, and (4) 5/16”
Locknuts to bolt the console to the front roll bar.
15. Use (2)10-32x1 Button Head Screws and (2)3/16” Washers to bolt the rear assembly to the main
console. There are nuts in the top of the console that these screws will go into. Do not over tighten
.
Over tightening will cause the top of the console to warp down. See Figure 7.
Stock Jeep Wranglers Pre 2000, Stock Jeep Wranglers 2001-2002, Vehicles with a full roll cage
16. Using the (2) 5/16” Barrel Nuts tighten down the rear assembly around the roll bar. Be sure to slide
the bolts as far back as possible up against the roll bar.
17. Tighten the screws that you inserted in Step 10.
18. Mount the Stereo, CB, or speaker to the removable electronics support frame if desired or your
electronic equipment can be fastened directly to the console. Notice that there are holes on the back
flange of the bracket for securing a stereo support strap or similar support device.
19. Follow the manufacturer’s directions for connecting the supply wires to your electronic equipment.
20. Slide the Support Frame up into the lockable compartment (you will have to rotate the cam lock while
inserting the bracket) and fasten in place using (2)6-32 Flat head Phillips Machine Screws on the face
of the bracket and (2)6-32 Unslotted Hex washer Screws up through the bottom of the console into the
bracket. Do not over tighten, these small diameter screws cannot withstand a lot of torque and will
break if over-tightened. See Figure 8.
21. Use the Adjustable Stereo/CB Support Bracket and (2)6-32 Flat Head Phillips Machine Screws to
secure the top of your electronic equipment.
22. Install the 1” Grommets in the holes on both sides of the console. If you need to route a CB
microphone or other cables through the hole simply slice the middle of the grommet.
23. Lock it up!!
Call [phone] for Technical Support