User manual

4
OWNER'S MANUAL
•
F20
SEAT
1. Unscrew the seat support’s locking knob
counterclockwise and pull the knob out.
2. Push the seat support in place and tighten with
the locking knob clockwise.
3. Attach the seat to the seat support: tighten the
locking nuts in opposite directions. Please note
that you can adjust both seat inclination and the
distance of the seat from the handlebar. Once the
distance and inclination are set how you want,
tighten the locking nuts carefully.
HANDLEBAR SUPPORT TUBE
1. Remove the 6 washers and screws from the
frame tube.
2. Adjust the resistance knob to position 1. Attach
the break wire from the handlebar support tube to
the break wire connector in the frame tube.
3. Attach the wires from the frame tube and
the handlebar support tube. Push the handlebar
support tube into place inside the frame tube.
4. Secure the handlebar support tube with 6
washers and screws.
HANDLEBAR
1. Thread the wire from the handlebar through the
hole in the handlebar tube and out through the top
of the tube.
2. Install the handlebar. IMPORTANT! The
handlebar pin must be aligned with the groove in
the socket!
3. Place the socket’s mating piece over the
handlebar attachment point and tighten with a
fastening screw and two washers through the upper
screw hole.
IMPORTANT! Do not overtighten the
fastening screw: you should be able to adjust the
position of the handlebar.
4. Place the plastic cover over the handlebar
attachment point.
5. Place two washers and a bushing over the
handlebar fastening screw and tighten fastening
screw through the lower hole in the plastic cover.
Be careful not to damage the wire!