Installation Instructions

ASSEMBLY AND INSTALLATION
INSTRUCTIONS
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. The combined weight of your ceiling fan and light kit cannot exceed 35 pounds unless
additional support is provided for the fan.
355-3166
131015
Turn of the Century
TM
Installing the fan light on fans with Non-Removable
switch box:
WARNING:
As per EPACT 2005 requirements, this fan light has a built-in current
limiting device to conserve energy. The fan light will not operate if the
combined wattage of the installed bulbs exceeds 190 Watts. If the fan
light shuts off shortly after being switched on, it may be due to
excessive current demand. You should replace the light bulbs with
lower wattage bulbs.
Glass Shade
Pull Chain
Bulb Type B Max.60W
(included)
Ball Nut
Frame
1. Unscrew the three screws from the switch box,
remove the switch box cover and disconnect the
wire nuts. (See Fig. 1)
2. Push the center plug from inside the switch box
cover to remove the center plug. (See Fig. 1)
Note: Save the center plug should you choose to
remove the light fixture in the future.
3. Feed the two wires from the fan light kit through the
rubber pad and the switch box cover, and thread the
wires through the washer and hex nut, then secure
switch box cover onto the fan light kit with a hex nut
and washer. (See Fig. 2)
4. Remove the wire nuts from the two wires in the
switch box labeled “FOR LIGHT KIT CONNECTION”.
5. Connect wires by using the wire nuts: (See Fig. 2)
---The black (hot) wire from fan light kit to the blue
(hot) wire from the fan.
---The white (neutral) wire from fan light kit to the
white (neutral) wire from the fan.
---Carefully put wires back into the switch box.
6. Restore the switch box cover back to the switch box
by using the three screws. (See Fig. 2)
7. Thread the fun pull chain through the hole of fan light kit. (See Fig. 2)
Note: Make sure that the pull chain from fan in a perpendicular line.
8. Install bulbs (included). See relamping label at socket area or packaging for maximum
allowed wattage. (See Fig. 3)
9. Place the glass shade into the frame as shown in Fig.2, attach the frame to the fan light kit,
secure them with ball nuts. (See Fig. 2)
10. Turn on the electric circuit.
Motor
Switch Box
Hex Nut
Screw
Switch Box Cover
Nipple
Wire Nut
Washer
Center Plug
----This FAN LIGHT can be installed in one of two ways.
----This fan light is not compatiable with ceiling fans
containing an integrated light kit.
Fig.1.
Switch Box Cover
Screw
Switch Box
Fig.2.
Wire Nut
Fan Light
Rubber Pad