Installation Instructions

Terminals
131015
Turn of the Century
TM
1. Unscrew the three screws from the fan, remove the
switch box and disconnect the terminals. (See Fig. 3)
2. Push the center plug from inside the switch box to
remove the center plug. (See Fig. 3)
Save the center plug should you choose to remove
the light fixture in the future.
3. Thread the two wires from the fan light kit through
the rubber pad and the switch box, then thread the
wires through the washer and hex nut, then secure
switch box onto the fan light kit with a hex nut and
washer. (See Fig. 4)
4. Remove the wire nuts from the two wires in the
switch box labeled “FOR LIGHT KIT CONNECTION”.
(See Fig. 5)
5. Connect wires by using the wire nuts: (See Fig. 5)
---The black (hot) wire from fan light kit to the blue
(hot) wire from the switch box.
---The white (neutral) wire from fan light kit to the
white (neutral) wire from the switch box.
---Carefully put wires back into the switch box.
6. Connect the two terminals respectively from the fan
and switch box. (See Fig. 5)
7. Restore the switch box back to the fan by using the
three screws. (See Fig. 6)
8. Thread the fun pull chain through the hole of fan
light kit. (See Fig. 2)
Note: Make sure that the pull chain from fan in a
perpendicular line.
9. Install bulbs (included). See relamping label at socket
area or packaging for maximum allowed wattage.
(See Fig. 6)
10. Place the glass shade into the frame as shown in
Fig.2, attach the frame to the fan light kit, secure
them with ball nuts. (See Fig. 6)
11. Turn on the electric circuit.
Switch Box
Fan
Wire Nut
Center Plug
Fig.3.
Screw
Fig. 5
Screw
Terminals
Switch Box
Fan
Switch Box
Terminals
Fig. 6
Black Wire from
Fan Light
Blue Wire from
the Switch Box
White Wire from
Fan Light
White Wire from
the switch Box
Installing the fan light kit on a removable switch box:
Fig. 4
Hex Nut
Nipple
Washer
Switch Box
Terminals
Glass Shade
Pull Chain
Bulb Type B
Max.60W (included)
Ball Nut
Frame
Fan Light
Rubber Pad