Right Instructions
Min Servo Engine Sectionboard
The product is mainly used for the servo with large regular vane’s airplane，such as gasoline engine. This product can distribute
several strings’ power. The sectionboard integrates CDI remote flameout swiches and reserves position for receiver, which make
servo’s lines convenient and tidiness. If you use double powers input to the power supply, it will be more stable and more security.
Produce features:
1. Eight channels for input, and sixteen channels for output.(every one channel input with two channels output )
2. Integrates CDI remote flameout swiches. Through each channel of the remote controller or swich channel(usually choose a
switch channel) can make the gasoline engine’s CDI on or off by remote control.
3. Independent CDI power supply socket. Receiver power completely separates with the CDI power, so you should not worry
about that CDI arouses high frequency signal will interfere the receiver, and the LED display the state of the power supply at
real time.
4. LED display the state of the electric voltage at real time, and LED can display in two colours.
5. There are four leds display the sectionboard’s working states at real time.
6. The servo supplys power, at the same time diode directly connectes with the battery. The voltage drop is approximately 0.3V.
7. Receiver supplys power:
Direct connection: When sectionboard uses 5V- 6V to supply power, then you can choose “direct connection”.
Voltage drop 0.5V: When sectionboard uses 6V and you don’t like the receive power too hight, then you can choose “voltage
drop 0.5V”.
Voltage drop 7805: When sectionboard uses 7.2V- 8.4V high voltage to supply power, then you can choose “voltage drop 7805”.
Technology parameters:
1. Working voltage: 5V-8.4V
2. Servo’s working electricity:0A-30A
3. Weight: 70g
4. Volume:116mm(long)*88mm(wide)*13mm(height)
5. Working temperature:-20℃ to 85℃.
CDI signal states of the power supply:
the green light on the green light flash the red light on the red light flash
voltage above 4.8V 4.5V-4.8V 4.2V-4.5V voltage below 4.2V
Distributed by HiModel.com
A Receiver’s working power indicator light.
B Receiver binding with magic ribbon.
C CDI working power indicator light.
D CDI power output terminal.
E CDI power input terminal.
F CDI power voltage indicator light.
G Number 2 battery’s input terminal and indicator light.
H Number 1 battery’s input terminal and indicator light.
I Fixed hole of the sectionboard.
J A padded cushion，location of the receiver.
K One to eight channel’s output terminal.
L The supply power’s selection terminal of the receiver:
a. Pin 1 & 2 short circuit is direct connection.
b. Pin 2 & 3 short circuit is 0.5V voltage drop.
c. All pins open is 7805 voltage drop.
M One to eight channel’s input terminal and CDI input channel.