manual

Failure to connect as shown in this
diagram will damage this charger.
To avoid short circuit between the charge
lead always connect the charge cable to
the charger first, then connect the battery.
Reverse the sequence when
disconnecting.
WARNING:
OPERATING PROGRAM
Here is the detailed procedure to make the charger work. All the screens and
operations will take Li-Po BALANCE CHARGE program for example,
1. Connection
Connecting to power source
It is an AC charger only.
Please
insert
the AC
power
cord
to the
wall
socket (100-240V) directly to
power it on.
Connecting the battery
Important!!! Before connecting a battery it is absolutely essential to check one
last time that you have set the parameters correctly. If the settings are
incorrect, the battery may be damaged, and could even burst into flames or
explode. To avoid short circuits between the banana plugs, always connect the
charge leads to the charger first, and only then to the battery. Reverse the
sequence when disconnecting the pack.
Balance Socket
The balance wire attached to the battery must be connected to the charger
with the black wire aligned with the negative marking. Take care to maintain
correct polarity! (See the wiring diagram below.)
This diagram shows the correct way to connect your battery to the TURNIGY
ACCUCELL S60 while charging in the balance charge program mode.
1).
2).
3).
· 10
ACCUCELL S60
In default setting, for safety issue, it requests to use balance charging
wire with balance board to charge Lithium batteries in all modes.
If the charging battery has no balance wire, please disable this function in
system setting program as following,
BATT/PROGRAM
SYSTEM SETTING->
Bal. Connection
ON
ENTER
START
Bal. Connection
OFF
INC/DEC
START