i6S TX Manual

4. Operation Instructions
After setting up, follow the instructions below to operate the system.
4.1 Power On
Follow the steps below to turn on the system:
1. Check the system and make sure that:
• The batteries are fully charged and installed properly.
• The receiver is off and correctly installed.
2. Hold the power buttons until screen lights up.
3. Connect the receiver power supply to the
B/VCC
port on the receiver.
The system is now powered on. Operate with caution, or serious injury could result.
4.2 Binding
The transmitter and receiver have been pre-bound before delivery. If you are using another transmitter or
receiver, follow the steps below to bind the transmitter and receiver:
1. Turn the transmitter on, press
, and scroll down and then select [
RX bind
].
2. Connect the bind cable to the
B/VCC
port of the receiver.
3. Connect the power to any other port. The indicator will start to flash, indicating that the receiver is in
bind mode.
4. Remove the bind and power cable from the receiver. Then connect the power cable to the
B/VCC
port.
5. Check the servos' operation. If anything does not work as expected, restart this procedure from the
beginning.
4.3 Pre-use Check
Before operation, perform the following steps to check the system:
1. Check to make sure that all servos and motors are working as expected.
2. Check operating distance: one operator holds the transmitter, and another one moves the model
away from the transmitter. Check the model and mark the distance from where the model starts to
lose control.
Danger · Stop operation if any abnormal activity is observed.
Danger · Make sure the model does not go out of range.
Attention · Sources of interference may affect signal quality.
4.4 Power Off
Follow the steps below to turn off the system:
1. Disconnect the receiver power.
2. Hold the transmitter's power buttons to turn off the transmitter.
Danger
· Make sure to disconnect the receiver power before turning off the transmitter.
Failure to do so may lead to damage or serious injury.
9