i6S TX Manual

6.2 End Points
6. Function Settings
6.1 Reverse
6.3 Aux. Channels
The auxiliary channels can be used to control additional part of a model such as landing gear or lights.
1. Select channels using the left or right arrow keys on the screen on either side of the channel name.
2. The left box below the channel name allows the user to pick the type of control for that channel, Nul,
VRx, Stx, KEY and SWx.
The reverse function changes a channels direction of movement
in relation to its input. For example, if the blades are spinning in
the wrong direction, pushing the model into the ground instead
of taking off, this function can be used to correct this.
Setup:
To change between normal and reverse touch the box to the
right side of the desired channel.
Nor = Normal, Rev = Reverse.
Select the
icon to save and return to the previous menu.
The end point function changes the range of movement available to a channel. This can be used to limit
the tilt of the model, so that it is easier to control.
The left box is the low end point, the right box is the high end point, marked below as low being blue and
red being high.
To change an end point:
1. Touch the low or high end point box.
2. Touch the desired decimal to change then use the onscreen
up and down arrows to change the value.
3. Press the or to confirm or cancel changes.
4. Select the
icon to save and return to the previous
menu.
3. Select the icon to save and return to the previous menu.