i6S TX Manual

6.4 Subtrim
Subtrim changes the center point of the channel. For example, if a model is always drifting to one side,
To set the subtrim function:
To change the subtrim:
1. Touch the box to the right of the desired channel.
2. Select the correct decimal and use the up and down arrow keys.
3. Press the or to confirm or cancel changes.
4. Select the icon to save and return to the previous menu.
13
6.5 Trims
To activate trim select trims in the menu. The box to the right of the word “Trims” displays the current
state of the trims function, to turn on the trim function, select “On”.
6.6 Mix
The mix function creates a mix between 2 different channels. For example, it is possible to make a mix
between rudder and ailerons, so whenever the model rolls, the rudder will move automatically to perform
a turn.
Note: In order to make changes to the mix ,it must first be disabled.
• Master: This channel will control the slave.
Setting a trim:
1. From the home screen swipe from left to right to display channel positions.
2. Move the control surface so that the channel is in the desired position.
3. Press and hold the button on the back, opposite side of the system for 4 seconds.
• Slave: This channel is controlled by the master.
• offset: Offset works like trim or sub trim allowing for the centre position of the slave channel to be
changed.
• Pos: Changes how much the slave will move in relation to the master in a positive movement. At 50%
when the master moves to 100% of its positive motion, the slave will move to positive 50%.
the subtrim can be used to fix this.