i6S TX Manual

Setup:
1. If the mix is not already disabled turn it off by touching the box labeled "on".
2. Select a master by touching the box to the right of the master channel and choose a channel from the
list.
3. Select a slave by touching the box to the right of the slave channel, then choose a channel from the
list.
4. If needed, set an offset on the slave channel. Select the box to the right of the offset function, select
the correct decimal and use the up and down arrow keys to change the value. Press the
confirm or cancel changes.
5. Set the positive ratio using the box to the right of "pos", select the correct decimal and use the up
and down arrow keys to change the value. Press the
or to confirm or cancel changes.
6. Set the negative ratio using the box to the right of "neg", select the correct decimal and use the up and
down arrow keys to change the value. Press the
or to confirm or cancel changes.
7. Once all changes have been made toggle the function to on by touching the box to the right of "Mix".
8. Select the
icon to save and return to the previous menu.
6.7 Failsafe
The failsafe function enables you to pre-set channel positions for the receiver in case of signal loss.
Setup:
1. To setup a failsafe position on a channel, select the channel from the
list, to select the channel touch the box to the right of the channel
name.
2. The box next to the channel name should display "On", to activate the
failsafe touch the box. The box should now display "Off".
3. Move and hold the channel at the desired position, then while keeping
the channel at the desired value touch the setup box.
Set all:
It is possible to set all the channels at the same time, to do so first turn
all the channels on as stated above, hold all the channels in the desired
position and select "Set all" at the bottom of the list. The system will
prompt for a confirmation, select "Y" for yes.
To Reset all channels, select the "Reset all" option.
Select the
icon to save and return to the previous menu.
• Neg: Changes how much the slave will move in relation to the master in a negative movement. At
50% when the master moves to 100% of its negative motion, the slave will move to negative 50%.
or to