i6S TX Manual

3. Getting Started
Before operation, install the battery and connect the system as instructed below.
3.1 Transmitter Battery Installation
Danger · Only use specified battery.
Danger · Do not open, disassemble, or attempt to repair the battery.
Danger · Do not crush/puncture the battery, or short the external contacts.
Danger · Do not expose to excessive heat or liquids.
Danger · Do not drop the battery or expose to strong shocks or vibrations.
Danger · Always store the battery in a cool, dry place.
Danger · Do not use the battery if damaged.
Follow the steps to install the transmitter battery:
1. Open the battery compartment.
2. Insert 4 fully-charged AA batteries into the compartment. Make sure that the batteries are inserted in
the correct polarity and make good contact with the battery compartment's contacts.
3. Replace the battery compartment cover.
3.2 Connecting the Receiver and Servos
Connect the receiver and the servos as indicated below:
Battery
Switch(Optional)
B/VCC
i-BUS/S-BUS
CH6
CH5
CH4
CH3
CH2
PPM/CH1
PPM(Optional)
Aileron servo
Elevator servo
Throttle servo
Rudder servo
i-BUS/S-BUS(Compatible)
PPM/CH1
CH2
CH3
CH4
CH5
CH6
B/VCC
i-BUS/S-BUS(Compatible)
Sens