Computer Hardware User Manual

Tiger i7320 S5350 Chapter 2: Board Installation
2-14
http://www.tyan.com
2.6.1 Installing Memory
Before installing memory, ensure that the memory you have is compatible with the
motherboard and processor. DDR 266/333 modules are required. Check the TYAN Web site
at: www.tyan.com for details of the type of memory recommended for your motherboard.
The following diagram shows common types of memory modules.
Key points to note before installing memory into Tiger i7320:
• Always install memory beginning with DIMM4
• 128MB, 256MB, 512MB, 1GB, 2GB and 4GB* Registered ECC/Non-ECC
PC2700/PC2100 DDR SDRAM memory modules are supported
• All installed memory will be automatically detected.
• The Tiger i7320 S5350 supports up to 32GB* of memory.
• Registered ECC and non-ECC Memory is supported.
• Either single or dual-rank modules are supported.
• Memory modules of the same type and density are required for dual-channel DDR
operation. Mismatched memory may cause system instability.
* Not validated at the time of print; subject to change.
Refer to the following table for supported DDR-333/266 populations
(Note: S indicates a single rank DIMM, D indicates a dual rank DIMM)
DIMM Slot Population
B-DIMM4
SD S S DSS SDSSSSD
A-DIMM4
SD S S DSS SDSSSSD
B-DIMM3
SDDSS DDSSSDD
A-DIMM3
SDDSS DDSSSDD
B-DIMM2
SD DDSSDDD
A-DIMM2
SD DDSSDDD
B-DIMM1
SDDDD
A-DIMM1
SDDDD
Note
Intel E7320 chipset specification lists a limitation of 8 banks of DDR333
memory. However, by design the Tiger i7320 supports up to 16 banks of
DDR333 memory. Please note that this a feature of Tyan’s breakthrough
engineering design, and similar memory support may not be present on
competitor products that use the Intel E7320 chipset