TP-MS4x4 4 Port Gigabit PoE Injector USER’S MANUAL TYCON POWER SYSTEMS
User’s Manual TP-MS4x4 V5 1. General Information The TP-MS4x4 is a DC/DC PoE (Power over Ethernet) Injector, provide up to 4 different voltage DC input and four different voltage PoE output, output power maximum 1A/port, data rate can be 10M/100M/1000M. The polarity of each PoE output can be reversed if you need to reverse the output polarity. This manual will help you to install and setting the PoE injector. 2.
User’s Manual TP-MS4x4 V5 *LED Indicator There are 4 LEDs on the front panel to indicate the input and output power status of each port. LED STATUS 1~4 Green Description A valid power device is detected on this port. Active current is 80mA. Red No power device is detected on this port. Off No input power apply, or input source alarm. Alarm voltage is less than 58VDC, or larger than 10.5VDC. Alarm current is 2A.
User’s Manual TP-MS4x4 V5 *Power Input The input voltage of TP-MS4x4 is 12VDC to 57VDC, it is common negative design, the green terminal (CON1) on rear panel is used for power input wiring, it can be connected to maximum 4 different sources with 4 different voltages, the jumper A, B, C, of JP1 on rear panel controls the input/output connection, its setting as below.
User’s Manual TP-MS4x4 V5 *PoE Output The bottom ports 1-4 on the front panel are used for carry PoE output, the output voltage is the same as input, no regulated. Normally as detailed below: * Data pair A on line 1 and 2 * Data pair B on line 3 and 6 * Data pair C plus V+ on line 4 and 5 * Data pair D plus V- on line 7 and 8 *Output Polarity Reverse (for technician operation only) The TP-MS4x4 may deliver PoE output with reverse polarity.
User’s Manual TP-MS4x4 V5 4.
