USER MANUAL Drawer Refrigerator 2075

User’s Manual

TEMPERATURE CONTROLLER

Figure 17

The temperature controller (Figure 17) is located in the top

drawer. It consists of an LED display, two LED status indicator lights and

three touch pad buttons. The LED display shows the temperature set

point and is calibrated in degrees Fahrenheit. The controller is factory

programmed for a set point of 38°F which will show when the unit is first

powered-up.

To display actual temperature, press the “WARMER” button momentari-

ly. A solid status indicator light (1, Figure 17) will show the air tempera-

ture reading in the cabinet for approximately 10 seconds.

To adjust the temperature set point, press the “SET TEMP”

button momentarily; the display will flash. Press the “WARMER” or

“COOLER” button as desired to change the set point. When the desired

set point shows on the display, wait 10 seconds and the new set point

will be saved. Wait 24 hours for the temperature to stabilize before

checking the actual temperature again.

Refer to Table 1 to determine indicator light status.

LED Status Indicates

1• Solid • Refrigerator Temperature displayed

• Flashing • Not Applicable

2• Flashing • Open Thermistor – call for service

Table 1. Indicator Light Status

SET

TEMP

WARMER

COOLER

CLRCO011B

1 2