Manualshelf

User's Manual

ManualsBrandsUbiquiti Networks ManualsElectronicsDigital Point-to-Point Radio
19202122232425262728
b. Loosen the six elevation bolts, and use the hex nut on
the elevation rod to adjust the elevation.
Note: Do NOT make simultaneous adjustments on
the Master and Slave.
2. Slave Visually aim the Slave at the Master. To adjust the
Slave’s position:
a. Loosen the four pole clamp nuts, and rotate the airFiber
antenna on the pole to align the azimuth.
b. Loosen the six elevation bolts, and use the hex nut on
the elevation rod to adjust the elevation.
3. Check to see if a link is established. Ensure that the LINK
LED is solidly lit green and the Signal LEDs of the Slave are
displaying signal levels.