User's Manual

! !

Quick Installation & Start Guide

The UgMO UG1000R Repeater is part of the

UG1000 family of products. The Repeater

extends range and helps form a multihop

above ground mesh network between

controllers, bridges and other repeaters of

the UG1000 product family.

• Remote configuration and alert reporting

• Software upgradeable to allow for future

feature expansion

PAGE 1
Quick Installation & Start Guide The UgMO UG1000R Repeater is part of the UG1000 family of products. The Repeater extends range and helps form a multihop above ground mesh network between controllers, bridges and other repeaters of the UG1000 product family.
PAGE 2
UG1000 Wireless Repeater The UG1000R Wireless Repeater serves as a range extender. This device is able to join an above ground multihop mesh network which then allows signals from underground sensors to travel above ground and reach controllers (UG1024 or UG1012), other repeaters and Bridges (UG1000B). The UG1000R is typically installed outdoors and is wall mounted. The Repeater is powered using a wall wart that is supplied with the unit.
PAGE 3
A repeater after powering up joins an existing above ground Unet. This implies a controller or bridge must already be present in the network for the repeater to be able to join the network. Once powered, a red LED on the front of the Repeater will aluminate followed by a series of Green LEDs as the bridge searches the area for any existing hardware or networks. The LEDs are very helpful in determining the current state and operation of the bridge.
PAGE 4
Regulatory Notices FCC ID: YVAUG1000R; IC ID: 10216A-‐UG1000R M/N: UG1000R This device complied with Part 15 of the FCC Rules and Industry Canada License Exempt RSS Standard(s).