- Ultra Electronics Sprinter Installation Guide

ManualsBrandsUltra electronic ManualsPrinterMAGICARD 300

www.ultramagicard.com

300 & S

rinte

e-film installation

uide

To remove the dye-film carrier turn the “Dzus”

fastener ring a quarter turn counter-clockwise,

the dye film carrier can then be removed.

Remove the roll of dye film from its wrapper

and slide it over the bottom feed core.

Also fit an empty take up roll over the top core.

Important:-

Ensure the two locating notches are facing to

the left on both the top and bottom rolls, as

shown in diagram right>>>.

Notches

Replace the Film Carrier, with the empty take up

spool facing the top.

Summary of content (4 pages)

PAGE 1
www.ultramagicard.com 300 & Sprinter dye-film installation guide 1 To remove the dye-film carrier turn the “Dzus” fastener ring a quarter turn counter-clockwise, the dye film carrier can then be removed. 2 Notches Remove the roll of dye film from its wrapper and slide it over the bottom feed core. Also fit an empty take up roll over the top core. Important:Ensure the two locating notches are facing to the left on both the top and bottom rolls, as shown in diagram right>>>.
PAGE 2
www.ultramagicard.com 300 & Sprinter dye-film installation guide 4 It may be necessary to turn the take-up spool drive gear to ensure the two notches in the spool locate correctly with the locking pins. Manually turn the Spur Gear until the notches on the spool engage with the locking pins. 5 Turn the 'Dzus' Fastener 1/4 turn clockwise to lock in place. Lay the ring flat against the panel 6 Pull about 6" of dye film off the roll of dye film, observing that it should be coming off the top of the roll.
PAGE 3
www.ultramagicard.com 300 & Sprinter dye-film installation guide 7 Avoid touching the tip of the thermal printhead with your hands. Feed the leading edge of the dye film over the top of the Thermal Printhead and beneath the guide bar, stick the leading edge on the dye film to the take up spool with the white label provided. 8 Wind the dye film on a couple of turns to ensure it is centrally positioned on the take up core.
PAGE 4
www.ultramagicard.com 300 & Sprinter dye-film installation guide Special Note: How to fit UR3 Continuous Resin Dye Film and UR10 Single Colour Dye Film Before fitting the continuous resin black thermal transfer film dye film or the UR10 single colour dye film a small modification must be carried out on the take-up spool spigot before operating the printer. As this dye film has no panels the optical sensors are inoperative, so for correct operation it is important that this modification is carried out.