Instructions / Assembly

Issued/Revised: 08/23/13
3FT ADA STEPS 02-07-5039
uPLAY TODAY
800.458.5872
www.ultraplay.com
1
Parts List
PART NUMBER
QTYDESCRIPTION
02-07-01571BARRIER LEFT
02-07-01561
BARRIER RIGHT
02-07-004341" FOOTER
02-07-01551
ADA TRANSFER STAIR
02-07-00041ADA DECK
02-07-00471
ADA DECK SUPPORT POST
02-07-00111ADA HANDHOLD
02-07-00061
ADA STEP
02-07-006028 1/4" EXTENSION POST
02-07-00612
15" EXTENSION POST
02-07-00462FOOTER PLATE
33-12-00791
33-11-0003*
13
M10 x 25mm (1") BHCS BOLT
33-11-0005*
8
M10 x 35mm (1 3/8") BHCS BOLT
33-11-0010*
4
M10 x 50mm (2") BHCS BOLT
33-11-0007*2
M10 x 60mm (2 3/8") BHCS BOLT
33-11-0200*
32
M10 FLATWASHER
33-11-0400*27M10 LOCK NUT
33-11-0103*
12
M8 x 25mm (1") BHCS BOLT
33-11-0301*4M8 LOCKWASHER
33-11-0500*
8
M8 LOCK NUT
33-11-0700*4CLAMP RIVET
HARDWARE COMPLETE
Items listed below Hardware Complete line are included with Hardware Complete Number
Warning: During Installation, Hardware And Small Parts Are Choking Hazards For Young Children. Store
Unused Parts Appropriately Until Assembly Is Completed. Once Assembly Is Completed, Remove Any
Unused Parts From The Play Environment And Dispose/Save Them In A Secure Location. Any bolt end
protruding more than two full threads beyond the face of the nut causes risk of clothing entanglement.
Promptly cut-off flush, file smooth, and treat to prevent corrosion.
Unless Otherwise Specified, All Units of Measure are Each
Note: Peen Tee-Nuts and Flatwashers to match radius of pipe after assembly is complete.
Note: Loctite (supplied by others) should be used on any non-patch hardware.
INSTALLATION INSTRUCTIONS:
IMPORTANT:
DETERMINE WHICH MOUNTING OPTION YOU ARE USING; SURFACE MOUNT, ONGROUND, OR IN-GROUND.
1. Choose the appropriate hole in Barrier Footer for your surfacing application.
2. Attach Barriers to Barrier Footers using M10 x 35mm B.H.C.S. Bolt and M10 Lock Nut. See Detail 028.
3. Attach Barriers to Tube Clamps using M8 x 25mm B.H.C.S Bolt and M8 Lock Washer. See Detail 029.
4. Attach Tube Clamps to Uprights using M8 x 25mm B.H.C.S. Bolt and M8 Lock Nut. See Detail 030. (Do not install Clamp Rivet
until entire unit is assembled)
5. Clean all slots in stairs, decks, and steps with utility knife if necessary.
6. Attach ADA Transfer Step to Deck using M10 x 25mm B.H.C.S. Bolt, M10 Flat Washer, and M10 Lock Nut. See Detail 031.