SDS

ManualsBrandsUnbranded ManualsBuilding materials4 x 10' CCA .60 Ground Contact Pressure Treated Round Fence Post

SAFETY DATA SHEET

1. Identification

Product identifier CCA Treated Wood

Other means of identification

SDS number

92-KPC

Recommended use

Preservative Treated Wood for various weather protected and exterior uses.

Recommended restrictions

None known.

Manufacturer/Importer/Supplier/Distributor information

Company Name

Koppers Performance Chemicals Inc.

Address

1016 Everee Inn Rd., Griffin, GA 30224

Telephone number

770-233-4200

Contact person

Regulatory Manager, KPC Inc.

Emergency Telephone

Number

CHEMTREC 1-800-424-9300

E-mail

KPCmgrsds@koppers.com

2. Hazard(s) identification

Not classified.

Physical hazards

Category 1ACarcinogenicity (inhalation)

Health hazards

Combustible dust

OSHA defined hazards

Label elements

Signal word

Danger

Hazard statement

May cause cancer by inhalation. May form combustible dust concentrations in air.

Precautionary statement

Prevention

Obtain special instructions before use. Do not handle until all safety precautions have been read

and understood. Keep away from heat/sparks/open flames/hot surfaces. - No smoking. Keep

container tightly closed. Wear protective gloves/protective clothing/eye protection/face protection.

Prevent dust accumulation to minimize explosion hazard. Observe good industrial hygiene

practices.

Response

If exposed or concerned: Get medical advice/attention. Take off contaminated clothing and wash

before reuse. In case of fire: Use water fog, foam, carbon dioxide, dry chemical for extinction.

Collect spillage.

Storage

Store away from incompatible materials.

Disposal

Dispose of contents/container in accordance with local/regional/national/international regulations.

Hazard(s) not otherwise

classified (HNOC)

None known.

3. Composition/information on ingredients

Mixtures

1303-28-2 <3Arsenic Pentoxide

CAS number %Chemical name

1317-39-1 <1.5Copper Oxide

1308-38-9 <3.5Trivalent Chromium

N/A

92Wood

SDS USCCA Treated Wood

1 / 9

Summary of content (9 pages)

PAGE 1
SAFETY DATA SHEET 1. Identification Product identifier CCA Treated Wood Other means of identification SDS number 92-KPC Recommended use Preservative Treated Wood for various weather protected and exterior uses. Recommended restrictions None known. Manufacturer/Importer/Supplier/Distributor information Company Name Address Telephone number Contact person Emergency Telephone Number E-mail Koppers Performance Chemicals Inc. 1016 Everee Inn Rd.
PAGE 2
Composition comments All concentrations are in percent by weight unless ingredient is a gas. Gas concentrations are in percent by volume. Depending on the additives applied to the treating solution, this wood may also contain <1% of mold inhibitors, <1% of a non-hazardous oil emulsion, and <1% of a colorant. 4.
PAGE 3
6. Accidental release measures Personal precautions, protective equipment and emergency procedures Methods and materials for containment and cleaning up Use only non-sparking tools. Keep unnecessary personnel away. Keep people away from and upwind of spill/leak. Dust deposits should not be allowed to accumulate on surfaces, as these may form an explosive mixture if they are released into the atmosphere in sufficient concentration. Wear appropriate protective equipment and clothing during clean-up.
PAGE 4
US. NIOSH: Pocket Guide to Chemical Hazards Components Type Value Form Copper Oxide (CAS 1317-39-1) Trivalent Chromium (CAS 1308-38-9) Wood Dust (CAS N/A) TWA 1 mg/m3 Dust and mist. TWA 0.5 mg/m3 TWA 1 mg/m3 Dust. Biological limit values ACGIH Biological Exposure Indices Components Arsenic Pentoxide (CAS 1303-28-2) Value Determinant 35 µg/l Inorganic arsenic, plus methylated metabolites, as As Specimen Urine Sampling Time * * - For sampling details, please see the source document.
PAGE 5
Upper/lower flammability or explosive limits Not available. Flammability limit - lower (%) Flammability limit - upper (%) Not available. Explosive limit - lower (%) Not available. Explosive limit - upper (%) Not available. Vapor pressure Not applicable. Vapor density Not applicable. Relative density Not available. Solubility(ies) Solubility (water) Highly insoluble. Partition coefficient (n-octanol/water) Not available. Auto-ignition temperature Not available.
PAGE 6
Respiratory or skin sensitization ACGIH Sensitization Wood (CAS N/A) Dermal sensitization Respiratory sensitization Respiratory sensitization Exposure to wood dusts can result in hypersensitivity, Skin sensitization Exposure to wood dust can result in the development of contact dermatitis. The primary irritant dermatitis resulting from skin contact with wood dusts consist of erythema, blistering, and sometimes erosion and secondary infections occur.
PAGE 7
13. Disposal considerations Collect and reclaim or dispose in sealed containers at licensed waste disposal site. Do not allow this material to drain into sewers/water supplies. Do not contaminate ponds, waterways or ditches with chemical or used container. DO NOT BURN! Ash may be toxic and a hazardous waste; combustion vapors may be toxic. Dispose of contents/container in accordance with local/regional/national/international regulations. Dispose in accordance with all applicable regulations.
PAGE 8
SARA 311/312 Hazardous chemical Yes SARA 313 (TRI reporting) Chemical name Arsenic Pentoxide Copper Oxide Trivalent Chromium CAS number % by wt. 1303-28-2 1317-39-1 1308-38-9 <3 <1.5 <3.5 Other federal regulations Clean Air Act (CAA) Section 112 Hazardous Air Pollutants (HAPs) List Arsenic Pentoxide (CAS 1303-28-2) Trivalent Chromium (CAS 1308-38-9) Clean Air Act (CAA) Section 112(r) Accidental Release Prevention (40 CFR 68.130) Not regulated. Not regulated.
PAGE 9
Further information HMIS® is a registered trade and service mark of the NPCA. E - Safety Glasses, Gloves, Dust Respirator PERCENTAGE OF HAZARDOUS INGREDIENTS COMPONENT %: 0.25 pcf Arsenic Pentoxide 0.3%, Copper Oxide 0.15%, Chromium Trioxide 0.4%, Wood Dust* 84.28% 0.4 pcf Arsenic Pentoxide 0.4%, Copper Oxide 0.2%, Chromium Trioxide 0.6%, Wood Dust* 83.98% 0.6 pcf Arsenic Pentoxide 0.6%, Copper Oxide 0.3%, Chromium Trioxide 0.9%, Wood Dust* 83.47% 1.0 pcf Arsenic Pentoxide 1.0%, Copper Oxide 0.