Instructions / Assembly

1. Grip the sander with your thumb, index

finger, and middle finger.

2. Insert the pump on the drive shaft and

then grip the pump using your ring

finger and little finger.

3. Pump 1–2 times with small distinct thrusts.

TIP: Hold the

Guinevere sander

and pump in one

hand and pump with

the other hand.

Long Drum Sanders (8mm air shaft diameter vs 6mm

for round, drum & short sanders)

1. TO INFLATE: Tighten the brass ring on the micro pump

until it is finger tight.

Loosen the brass fitting on the micro pump by turning

it two half revolutions counter clockwise to allow sufficient space for the shaft to be

inserted into the brass fitting.

3. Place sanding sleeve over rubber bulb and slide it down with ends protruding

equally at the top & bottom.

4. We strongly recommend you fully extend the pump handle before inserting the

shaft of the sander securely into the pump.

5. Inflate using same hand positions as described and shown below or if this is

awkward or your fingers are too short, follow steps 1 – 3 and read on.

6. Lay two quarters or same diameter flat washers or spacers on top of each other on

a flat table surface. Stand the sander vertically on top so the sanding sleeve protrudes

about 1/8” (3.175mm) over the coins/washers and apply 4. above. Apply pressure so that

the vertical shaft inserts snugly into the brass ring of the pump.

7. While holding the sander with your left hand, use your

thumb & index finger to apply pressure to secure the hand

pump and sander. Make sure the shaft of the sander

remains inside the brass fitting while pumping.

8. Using your right hand, pump the handle down once.

To Deflate: Loosen the nut one full turn and wobble and

squeeze the sander until pressure is released.

TIP: Stand the long sander on top of 2 quarters so the

sanding slee

e protrudes about 1/8” (3.175mm) over

the coins.

4 - GUINEVERE

GUIN_Instru_2012 1/12/15 5:20 PM Page 4