Installation Guide

INSTALLATION INSTRUCTIONS

PREPARATION

Before beginning assembly of product, make sure all parts are present. Compare parts with

package contents list and hardware contents list. If any part is missing or damaged, do not attempt

to assemble the product.

Estimated Installation Time: 45 minutes (24 hours for silicone caulk to dry).

Tools Required for Installation (not included): Phillips screwdriver, utility knife or scissors, silicone

caulk, power drill with drill bit, measuring tape, level

1. With 2 people, place the vanity on its back on

a flat, scratch free surface. Locate the Center

Support Leg (J) and screw into the base of the

vanity. Once complete, lift the vanity back up

into the upright position.

2. To remove small drawers (I) from vanity base

(A), fully extend drawers and locate the plastic

levers on left and right sides of the metal glide

tracks. Push the plastic levers, on both sides,

at the same time, This will disengage the

drawer box from the glides. Gently lift up on

the drawer to remove it from the glide tracks.

Set aside as these will be re-installed.