Use and Care Manual

SNAP-JET GAS IGNITION SYSTEM MAINTENANCE

SNAP-JET GAS IGNITION

SYSTEMOPERATION

The burner control knob has a built-in igniter. The

igniter supplies a spark to the igniter electrode

assembly. Whether you are performing routine

maintenance or a troubleshooting check on the

SNAP-JET gas ignition system, read the following to

keep the system working properly.

m WARNING: The burner control knob should

be in the OFF position.

If the grill fails to ignite when you push the burner

control knob in and turn it slowly, you will need to

pinpoint where the problem is occurring: with the gas

flow or with the ignition system. Begin by attempting

to match light your burner. Refer to “BURNER

IGNITION – Lighting with a Match.” Ifmatch lighting

is successful, the problem lies in the SNAP-JET gas

ignition system.

MAINTAINING THE IGNITION

COMPONENTS

1. Confirm that grill is off and cool.

2. Check that the black wire is connected to the red

terminal on the valve (A).

3. Check that the white wire is connected to the

ground terminal at screw (B).