Instructions

ManualsBrandsUnbranded ManualsCars2201977 Universal point motor 16 V AC

Assembly

1. Refer to the diagram under "Components/connections".

2. Remove the switching wires from the casing.

3. Drill a hole with a diameter of approx. 12 mm underneath the switching plate into the model train board.

Make sure that there is enough room for both switching wires in the two end positions.

4. Cut out the drilling template in the "Drilling stencil" section.

5. Mark the mounting holes through the two mounting anges, paying attention to the spatial conditions.

6. Screw the switching wire to the corresponding side of the push rod.

7. Now use 2 screws to mount the points motor underneath your model train installation (with the mounting

anges pointing upwards towards the model train board). You can make ne adjustments using the xing

screws, by shifting the switching motor and by using the small lever on the shifting rod.

8. Risk of injury! Make sure that you shorten the protruding length of the shifting wire. The thicker wire may

not be shorter than 25 mm.

Disposal

Electronic devices are recyclable waste and must not be disposed of in the household waste.

At the end of its service life, dispose of the product according to the relevant statutory regulations.

You thus full your statutory obligations and contribute to the protection of the environment.

Technical data

Operating voltage ......................................16 V/AC

Current consumption .................................approx. 1 A

Travel range...............................................approx. 7 mm

Dimensions (W x H x D) ............................23 mm x 21 mm x 67 mm

Weight .......................................................approx. 34 g

Components/connections

46 mm

12 mm

28 mm

Mounting bores

Holes for switching wire on the right or left, depending on spatial conditions.

Elongated holes or round holes 12 mm in diameter are possible.

Drilling stencil

(please cut out)

Model train board

Mounting anges

After removing the switching wires, this button can be used to

secure the push rod in the middle for exact mounting.

Adjustment rod

Brown

Red

Yellow to the core

To the 16 V/AC transformer

Blue (right) to the straight track section on the right

Blue (left) to the curved track section on the left

Switching wire

The connections to the switching station

can be found on the shrunken diodes.

This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com). All rights including

translation reserved. Reproduction by any method, e.g. photocopy, microlming, or the capture in electronic data processing

systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication represents the

technical status at the time of printing.