Full Product Manual

10
Assembly - Hanging the Fan (continued)
Making the electrical connection
3
□ The fan comes with 54 in. lead wires for use with an extended
ball/downrod assembly. If using the 4.5 in. ball/downrod
assembly (B) provided, you can cut the lead wires to your
desired length (no shorter than 12 in.) This will make extra
room in the canopy (C), if you do not wish to cut the wires,
you will need to neatly wrap them.
□ Connect the ground conductor of the 120-Volt supply (this
may be a bare wire or a wire with green colored insulation)
to the green ground lead(s) of the fan. When using standard
ceiling mounting, there are two green grounding leads; one
from the ceiling mounting bracket and one from the ball/
downrod assembly. When using close to ceiling mounting,
there is only one green grounding lead from the ceiling
mounting bracket since the ball/downrod assembly is not
used.
□ Connect the fan motor white wire to the household white wire
using a wire connecting nut (CC).
□ Connect the fan motor black and blue wires to the household
black wire using a wire connecting nut (CC).
□ Secure each wire connecting nut using electrical tape.
□ Turn the wire connecting nut (CC) upward and push the wiring
into the outlet box (NN).
IMPORTANT: Use the wire connecting nuts (CC) supplied with your
fan. Secure the connectors with electrical tape and ensure there
are no loose strands or connections.
NOTE: The fan comes with 54 in. lead wires for use with an
extended ball/downrod assembly. If using the 4.5 in. ball/downrod
assembly (B) provided, you can cut the lead wires to your desired
length (no shorter than 12 in.).
WARNING: Remove the rubber motor stops on the bottom of the
fan before installing the blades or testing the motor.
Outlet box
in the ceiling
NN
Green or Bare
Green
Black White
Blue & Black
White