User Manual

IGNITION UNIT MOUNTING
1. Make sure to install the power switch．
2. Push the spark plugs cap all the way over the spark plugs.(use gloves)
3. Fixate the unit within the fuselage far away from the receiver by cable ties.
FUEL AND PIPING
For gasoline，please use either regular or high octane，for cars．(The octane number
should be 93 or higher)．
For oil, use a high-performing mixed lubrication type of 2-cycle engine oil (FB grade
or ISO EGC grade) and make the fuel volume ratio 1(oil) to 25-40(gasoline).
For fuel piping．Do not use a silicon tube．Clip the weight so that it does not come off
when the engine is running．
1. Fuel tank capacity of 300-400cc
2. Carburetor
3. Weight
4. Filter mesh, 300 or more
5. Fuel pipe gasoline-resistant rubber or vinyl tube type with inner
diameter of 2.5-3mm
6. Fuel pipe gasoline-resistant rubber tube
7. Air vent pipe
8. Fuel head 100mm or less
ITEMS TO CONFIRM BEFORE STARTING THE ENGINE
●Please determine the propeller to use in keeping with the airplane’s size, gross weight.
And flight characteristics. If necessary, consult with someone who has the proper
experience.
Temperature: -20～85℃
Relative humidity: 80%
Introductions for Use:
Caution: If the power voltage is more than 7V, it will destroy the Ignition. If it is larger
than 10V, it will cause explosion.
Please read it carefully in order to make the Ignition running steady and make gasoline
engine fully exert its performance. Also please following the below to operate it.
●To make sure whether the battery power is match or not, and to insure have enough
Current capacity.
●Please use resistance Spark Plugs in order to reduce theelectromagnetic interference.
l Demand adopting shielding line links the hall parts can better to eliminate
electromagnetic interference.
l To cause interference please separate high voltage ignition line and Hall
Transducer.
l It adopts negative pulse ready to ignite, to make sure Hall Transducer please insure
to output for the anode, otherwise lighting firearms doesn’t work.
l Install Spark Plugs cap exactly and to be made shielding steel casing and Spark
plugs good and secure.
l When installing, please pay attention not to install electronic igniters on engine
directly, so as to avoid high temperature make the ignition doesn’t work normally.
The electronic igniter system shall have a distance with the receiver.system in order to
prevent a destruction achieved.