Instructions / Assembly

ManualsBrandsUnbranded ManualsOutdoor Side TablesCornbread Patio Side Table

END/SIDE TABLE

ASSEMBLY INSTRUCTIONS

Thank you for purchasing our quality Side Table. The product you have purchased

requires some assembly. This item has been carefully inspected before packing to

ensure it’s adherence to our strict Quality Control Standards. Proper assembly will

ensure not only your safety, but many years of enjoyable use of this quality product.

We STRONGLY suggest that you familiarize yourself with these instructions prior

to assembling this product. It’s up to you to follow carefully EACH STEP of the

assembly process. For your safety, DO NOT SKIP any step indicated in these

instructions. Use all the hardware provided as indicated. Be sure to tighten all

fasteners securely. The manufacturer will not be responsible for any damage or

injury that results from improper assembly of the table. If you have any questions

regarding the assembly of this table, feel free to contact us using the Helpline (800)

251-3025.

Summary of content (6 pages)

PAGE 1
END/SIDE TABLE ASSEMBLY INSTRUCTIONS Thank you for purchasing our quality Side Table. The product you have purchased requires some assembly. This item has been carefully inspected before packing to ensure it’s adherence to our strict Quality Control Standards. Proper assembly will ensure not only your safety, but many years of enjoyable use of this quality product. We STRONGLY suggest that you familiarize yourself with these instructions prior to assembling this product.
PAGE 2
SIDE TABLE ASSEMBLY INSTRUCTIONS A B C Parts Included: 1- Table Top (A) 4- Nuts and Washers (B) 4- Table Legs (C) Tools Required For Assembly Crescent Wrench or 1/2” Wrench 2
PAGE 3
**Attention/Stop** Please read before assembling this product! Our company has made every effort to provide you with a ready-toassemble product that has the same quality as our fully assembled rocking chairs. In the unlikely event that there are incorrect or missing parts or that parts become damaged during shipping, following the instructions below will protect you (The Customer) from accepting responsibility for a product that is damaged or incomplete.
PAGE 4
STEP 1: Lay Side table on the shipping box during assembly to protect it from scratching. Remove the rubber shipping plug on all 4 Table Legs (C) to expose the threads of the bolt. You may discard these as they are no longer needed. STEP 2: With Table Top (A) laying top down, line up the bolts on the Table Leg (C) with the pre-drilled hole on the corners of the table. Insert the bolt through the hole. If blot will not go through check to make sure Step 1 was completed.
PAGE 5
4 STEP 3: Once all Table Legs (C) are in place begin to attach the Nuts and Washers (B). Start by placing a washer on the bolt first and then thread the nut on finger tight. Complete this for all four corners of the table. STEP 4: Using a Crescent Wrench or ½” Wrench fully tighten all Nuts (B) securely. Your table is now ready for use. Note: This Side Table working load is 30 pounds and should never be used as a step ladder or to sit on.
PAGE 6
CARE TIPS LISTED BELOW ARE SOME TIPS TO HELP KEEP YOUR FURNITURE LOOKING NEW. To preserve the finish on stained or pure white furniture it is highly recommended that they either be placed indoors or in a protected environment such as a covered porch. In any case the finish will last longer and look better if kept out of direct sunlight and blowing rain. The finish on this furniture will last for a lifetime if used indoors. This furniture is not intended to be used in an unprotected environment.