Instructions / Assembly

STEP 1:
Lay Side table on the shipping box during assembly to protect it from
scratching. Remove the rubber shipping plug on all 4 Table Legs (C) to
expose the threads of the bolt. You may discard these as they are no longer
needed.
STEP 2:
With Table Top (A) laying top down, line up the bolts on the Table Leg (C)
with the pre-drilled hole on the corners of the table. Insert the bolt through
the hole. If blot will not go through check to make sure Step 1 was
completed. The bolt will not go through the pre-drilled hole with the
shipping plug still in place. Complete this for all four sides.