Installation Guide

For assistance call 1-844-372-6848 Monday through Friday, 7 am to 5 pm Mountain Time
or visit www.AgelessIronHardware.com
F
Door
Jamb
Attach the strike plate to the door jamb
using 3/4” long wood screws.
Install Strike Plate
E
Install Privacy Pin
D
Install Interior
with 1-1/2” machine screws
(1-3/8” thick doors), or 1-3/4”
machine screws (1-3/4” thick
doors)
Install Interior Half
of Lockset
Screw in the
Privacy Pin
(Privacy Only)
C
Emergency Release Hole
(Privacy Only)
Install Exterior Half
of Lockset
*
Latch Tongue Note
Bevel
Side
Face
Plate
Curve
Strike Plate Curve
Threaded
privacy hub
goes on the
inside of the
door.
Bevel side of latch tongue should
contact curved side of face plate,
and curved side of strike plate.
B
Install Latch
Install latch and rotate
the latch tongue
to change handing.
(See page 1 for handing)
Install anti-
rotation block.
Be certain
the arrow is
pointing to
the edge of
the door.
Install faceplate with
3/4” wood screws.
(Anti-Rotation
Block)
Arrow
1
2
3
Door - Inside See Latch Tongue
Note in next panel
*
*
A
Backset Information
For 2-3/8”
Backset:
For 2-3/4”
Backset:
NOTE:
DRILLING
TEMPLATES
ON
SEPARATE
INCLUDED
SHEET
Installation Instructions
Rosettes, Short and Long Plates
Fits doors
1-3/8” to 2” thick
Passage/Privacy
Tools Required: #2 Phillips Screwdriver (Not power tools)
Page 3 - PK#310 10.15.19
For assistance call 1-844-372-6848
Monday through Friday,
7 am to 5 pm Mountain Time
or visit
www.AgelessIronHardware.com