Installation Guide

For assistance call 844-372-6848 Monday through Friday 7am to 5 pm Mountain Time
or visit www.AgelessIronHardware.com
Page 1 PK #312 10.15.19
L
9
10
12
2
11
Door
Jamb
3/4
Install jamb strike plate.
K
7
8
Attach thumbturn
assembly with
provided screws.
Check deadbolt
operation by
turning thumbturn
and key.
Thumb-
piece
Check operation
by pressing the
thumbpiece down.
Tighten rosette/
short plate/
long plate screws
and check
operation again.
Tighten bottom
grip mounting
screw and
check operation.
Install bottom
mounting screw
cover.
Slide
handleset
up, hold,
and
tighten
deadbolt
screws.
17
Rosette/Short Plate/
Long Plate
Knob
19
18
1-3/4” Machine
Mounting
Screws
Install rosette/
short plate/
long plate on
door inside.
DO NOT
FULLY
TIGHTEN
THESE
SCREWS.
20
22
Bottom Grip
Mounting Screw
(part #21)
Insert bottom
grip ounting
screw.
DO NOT FULLY
TIGHTEN THIS
MOUNTING
SCREW.
Wait to install
the mounting
screw cover
until you have
completed
step J.
Door Inside
3
2”
6
Cylinder
5
Insert cylinder
into exterior
plate, and
place on door
outside. Attach
deadbolt
adaptor plate
with provided
screws.
DO NOT FULLY
TIGHTEN THESE
SCREWS.
Cylinder
Assembly (part #3)
Install cylinder into
exterior plate.
Door Inside
Deadbolt Latch
Tongue Note
Bevel Side
Face
Plate
Curve
Strike
Plate
Curve
Bevel side of latch tongue should
contact curved side of face plate,
and curved side of strike plate.
Latch Tongue
Note
14
14
2
2
13
13A
Tongue
Tongue
(See D Below
Before Deadbolt
Latch Installation.)
(See Latch
Tongue Note
in Panel C)
3/4”
3/4”
Install deadbolt
and handleset
latches.
USE INCLUDED DOOR PREPARATION
TEMPLATE FOR NON-PREPPED DOORS.
USE INCLUDED PLASTIC TEMPLATE TO
LOCATE AND DRILL THE 1/4” BOTTOM GRIP
MOUNTING HOLE. (See note on reverse side.)
1/4”
Fits Doors 1
-3/4
” to 2” Thick
Door Hardware
Installation Instructions
ROSETTE, SHORT & LONG PLATE
with
ONE-PIECE HANDLESET
Single Cylinder Handleset