Instructions / Assembly

Fig. 9
Fig. 7
Slide rail section in-between posts and on top of
temporary spacer blocks (position spacer blocks
next to installed vinyl posts) (Fig. 7).
For Top Brackets:
a. Center rail on post. Then, using a
5
⁄32" drill bit,
pre-drill the rst hole on an angle though the
top rail bracket, vinyl post jacket, and into
wood post
(or plastic spacer of post install kit) (Fig. 8).
b. Install the #10 x 2
1
⁄2"square drive screws (Fig.
9). Looking down from above, check to ensure
screws penetrate the wood post (or plastic
spacer of post install kit) (Fig. 10).
Fig. 10
Fig. 8
Rail
Screws
Post
Plastic
Spacer
Post
Install Kit
4
6.
7.
Slide the bottom rail bracket over bottom rail on
each end (Fig. 6).
Fig. 6
5.