Instructions / Assembly

Top Bracket Covers:
a. Ensure the railing is centered between both
posts and tighten the set screws put into the
metal brackets from Step 4.
b. Open the top rail bracket cover to allow it to
wrap around the top rail (Fig. 11). While open,
make sure the "tab" ts behind the rail and
against the post (Fig. 12).
c. While tightly squeezing the bracket cover
closed, pre-drill using a
5
⁄32" drill bit through
the two holes underneath. Then, drive two #10
x 1
1
⁄4" square drive screws through the cover,
metal bracket and into the top rail (Fig. 13).
Fig. 12
Fig. 11
Fig. 13
Top rail bracket cover
Tab
For Bottom Brackets:
a. Center rail on post. Then, using a
5
⁄32" drill bit,
pre-drill the rst hole on an angle though the
bottom rail bracket, vinyl post jacket, and into
wood post (or plastic spacer of post install kit).
b. Install the #10 x 1
1
⁄4" square drive screws (Fig.
14).
Bottom Bracket Covers:
Slide bottom bracket covers snugly onto bottom
brackets (Fig 15) .
Predrill and install screws
Fig. 14
Fig. 15
5
8.
9.
10.