Instructions / Assembly

After posts have been installed, determine angle and
height of railing (Fig. 1).
Pre-drill
1
⁄8 " diameter holes in base of top
bracket only. Then, fasten bracket to base at the
determined angle with two #10 x 1" square drive
screws (Fig. 2).
Cut railing to desired length. Place bracket on each
end of top and bottom rails (Fig. 3). Fasten bottom
bracket to base with one #10 x 1" square drive
screw.
a. Position the rail section between the posts
(Fig. 4).
b. Mark four screw hole locations on each bracket.
Set rail section aside, then pre-drill
1
⁄8 " diameter
holes in post at each mark (Fig. 5).
Fig. 1
Fig. 4
Fig. 5
ANGLE BRACKETS
Determine
Angle
Top View
Fig. 2
#10 x 1" Screws
Fig. 3
Top Rail
Bottom
Rail
Mark Holes
Mark Holes
Top View
9
1.
2.
3.
4.