Installation Guide

Instruction Manual | 8
TroubleShooting
Problem
Likely Cause
Remedy
Vacuum on, yet limited
production of fibrous insulation.
Throttle speed in idle mode.
Increase throttle speed. Note:
throttle does not need to be a
full speed for effective
vacuuming.
Kink in hose.
Review your hose assembly to
ensure no kinks in hose.
Small diameter hose used on
system’s inlet.
Utilize the largest diameter hose
the system will allow. Utilize
largest diameter hose for the
longest length possible from the
vacuum to the point of material
pick-up.
White smoke coming from
exhaust.
Engine (turbovac) tilted over 20
degrees and oil entered
carburetor.
Run engine until oil burns out of
carburetor.
Static Electricity shocking
operators.
Movement of insulation material
thru hose – more pronounced
during times of low humidity –
creates static electricity build-up
in vacuum hose.
Contact Intec technical service
at 800-666-1611. Options
include:
-Spraying warm water on hose.
-Grounding hose to dissipate
static electricity.