Instructions / Assembly

Smooth Side
of Holder
against Wall
Screw Side
of Holder
1. Install four HOLDERS on the stop side of the rough
opening, horizontally and four HOLDERS on the hinge
side, vertically. Make sure HOLDERS are smooth side to
the wall and snug. You may need to adjust later.
Note: Holes for HOLDERS are 6” down and 3/4” over from the rough
opening. Bottom holes are 6” up and from the bottom 3/4” over. See
illustration.
2. Place door & frame into rough opening. Hinges
facing you.
3. Turn HOLDERS 90 degrees / horizontal on the frame
(4 places.)
4. Center Door and Frame into rough opening. Make
adjustments and shim at the top-sides of the frame.
This should center door/frame into rough opening.
5. Level Hinge side rst. Place shims at hinge area
and nail.
6. Place shims on the Latch side making sure reveal is
equal space between door and frame. Open and close
door to check operation. If correct nail into place.
Note: About same location as hinge side
7. Cut all shims level with wall and
remove HOLDERS.
8. Trim door out.
9. Door Install Complete.
SEE NOTES
Doors always open into room. Hinges go on room side
Door Holder — Smooth side of holder always goes against
the wall.
Mounting of Holders — Holes for holders and screws are 6” down
and 3/4” over from rough opening and 6” up from the bottom and
3/4” over.
Holders Mount to backside of wall. Opposite door opening side.
Reveal (space between the frame and door) — should be close to equal
space at the top and latch side as possible.
Shims — Place shims at door hinge area.
Instructions
Hinges
Side
Stop
Side
Pan Head
Screw