Instructions / Assembly

Hammock & Stand Combo
With Hammock Pad & Pillow (model 8912)
Weight Limit: 275 pounds
Congratulations on purchasing this Hammock and
Stand, with hammock pad and pillow. We hope it
provides hours of relaxation. If you have questions
regarding this product, please contact customer
service at (800)-295-6758.
Your box should contain:
1 – Rope Hammock with chain assembly.
1 – Hammock Pillow.
1 – Hammock Pad.
1 – Unassembled Hammock Stand consisting of:
2 – Upright poles with attached S-hook ends.
1 – Center Pole.
2 – Leg assemblies.
1 – Hammock storage bag
NO TOOLS REQUIRED FOR ASSEMBLY
Assembly Instructions
Figure 1
Step 1. Place both leg assemblies on the ground with the upward curving elbows facing away from each other. Take the center-pole and
place on the ground between the two leg assemblies. Locate the holes on each end of the center-pole and face them up. Slide one end of
the center pole over the end of one elbow pole on the foot assembly. Push in silver lock- pin (Figure 1) and continue to slide pole until the
lock-pin pops through the hole. Repeat on the other side.
Step 2. Both upright poles have a pre-attached s-hook and end cap on one end and a lock-pin hole on the other. Take one upright-pole
and align the lock-pin hole with the other lock-pin on the elbow pole of the foot assembly. Slide the upright pole over the elbow pole, push
lock-pin down (Figure 1) and continue to slide pole until the lock-pin pops through the hole (Figure 2). Repeat on the other side.
Step 3. Unroll the cotton rope hammock and make sure it is not twisted or tangled. Each end of the rope hammock has an outdoor plated O-
ring with a chain attached. Attach one end of the hammock to the assembled hammock stand by placing the last link of the chain over the S-
hook on the upright pole. (Figure 3) Attach the other end of the rope hammock in similar fashion. (Note: The initial attachment of the rope
hammock to the stand may require more than one person as the rope hammock will likely need to be stretched taught to allow
attaching the chain. This is normal as the cotton rope hammock stretches considerably after using the hammock the first couple
of times. After the rope hammock has been used it will become much easier to attach.) Adjust height of hammock by adjusting the link
of chain you attach to the S-hook.
Figure 2
Figure 3
S-Hook
** TIP ** - if rope
hammock seems difficult
to attach, place your body
behind end of stand to
prevent stand from
sliding, then pull tight by
gripping O-ring. Attach
chain to stand using your
other hand.
Figure 4 Figure 5 Figure 6
Step 4. Unroll hammock pad and center on top of rope hammock. Secure the hammock pad to the hammock using the tie down straps
located at each corner and sides of hammock pad (6 straps). Using simple knots, tie the straps around each end of the spreader bars
(Figure4), and ropes on the side of hammock (Figure 5).
Step 5. To attach pillow, use simple knots using the tie-on straps on the back side of the pillow. Tie to wood spreader bar. (Figure 6)
Caution – Care should always be taken when using your hammock but especially when using your hammock for the
first time. Please always use extreme caution when getting into and out of the hammock. Never exceed weight
capacity. Never let young children use hammock unaccompanied by an adult. Always inspect hammock before use to
assure everything is appropriately attached. Make sure to read and follow hammock care and safety page.
>>>Please read and follow hammock care and safety instructions on separate page >>>>
**For your convenience
plastic pole ends and leg
ends are already fitted to
their respective poles.**