Installation Guide

INSTALLATION OF AMBIANCE
TM
HC-304
FOR YOUR SAFETY
INSTALLATION INSTRUCTIONS
Install according to all National and Local Codes. If you are
uncertain about how to proceed, contact a qualified electrician.
WARNING: BE SURE ELECTRICITY TO SYSTEM YOU
ARE WORKING ON IS TURNED OFF; EITHER THE FUSE
REMOVED OR THE CIRCUIT BREAKER SET AT OFF.
For 9409, 9412, 9413, 9416 Mini-Recessed Non-IC Housing
ASSEMBLY
1. Rotate clip for various material thicknesses (see Fig. 3).
HOUSING
FLANGE
CLIP SCREWS
CLIPS
*LAMP
*NOT INCLUDED
*TRIM OR
*GLASS SHADE
SOCKET LEADS
TRIANGULAR RIB
2 1/2" DIA.
HOLE TO
INSTALL
HOUSING
U.S. PATENT 5,249112
FIGURE 1
MAX. FEED WIRE SIZE BASED ON CEILING MATERIAL THICKNESS
MATERIAL NO. OF SETS OF NO. OF SETS OF NO. OF SETS OF
THICKNESS 14/2 ROMEX 12/2 ROMEX 14/2 BX
3/8" - 1" 2 (1 IN - 1 OUT 1 (IN ONLY) 1 (IN ONLY)
1" - 1 1/2" 1 (IN ONLY) 1 (IN ONLY) NOT APPLICABLE
WARNING: RISK OF FIRE. DO NOT INSTALL INSULATION
WITHIN 3 INCHES OF FIXTURE SIDES OR WIRING
COMPARTMENT, NOR ABOVE FIXTURE IN SUCH A
MANNER TO ENTRAP HEAT.
CAUTION: RISK OR FIRE. USE ONLY 12V LAMPS WITH
12V SYSTEMS. USE OF 12V LAMPS WITH 24V SYSTEM
MAY RESULT IN DAMAGE TO SYSTEM AND
SURROUNDING AREA.
NOTE: BE SURE NOT TO EXCEED THE MAXIMUM
ALLOWABLE AMPERAGE ON THE WIRE.
TO MAXIMIZE VOLTAGE DROP
WHEN USING 14/2 IN AND OUT, IT IS RECOMMENDED TO
HAVE MULTIPLE RUNS FROM THE TRANSFORMER TO
NO MORE THAN 3 FIXTURES PER RUN.
CHART 1
Installation And Safety Instructions
Line art shown may not exactly match the fixture enclosed. However, the installation instructions do apply to
this fixture. Fill in Item Number on Carton and File This Sheet For Future Reference. ITEM#_______________
HC-304
0
40204