Instructions / Assembly

ELECTRODE SPARK ADJUSTMENT
CAUTION: Spark can cause small shock. Do not leave
fingers on or near electrode wire while engaging igniter.
s%LECTRODEWIRESHOULDBE
approximately 1/8” from gas
EXITHOLEINBURNER
. Carefully adjust wire if required.
5
Retaining pin
Right
side
slot
Locking
Indents
A
Outer Shell
Liner
Liner Lip
DISASSEMBLY & RE-ASSEMBLY
s ,IFTRADIANTPLATEUPOUTOFLEFTSLOTSEE"ANDREMOVEBYSLIDINGITOUTOF
right slot (see C).
s2EMOVEBURNERRETAINERPINSEE"REMOVEBURNER)NSPECTBURNERREMOVEANY
OBSTRUCTIONS#!54)/.7(%.2%0,!#).'"52.%2#543,/43)."52.%2
-534&!#%$/7.
s
To remove liner from outer shell you must disconnect the electrode wire
SEE$&IRSTREMOVETHETWOSCREWSONVALVECHAMBERSEE$ANDREMOVE
THECOVERPLATE'ENTLYPULLWIREOFFCONNECTORSEE$)TISNOTNECESSARYTO
remove electrode from liner.
s 2EMOVE,IDANDLINERBYREMOVINGHINGESCREWSANDLOCKNUTSWITHvHEX
key wrench (supplied) and 1/2” wrench or pliers. CAUTION: LOCK NUTS
-534"%).34!,,%$7)4(,/#+).').$%.4-!2+33(/7).'SEE%
)-02/0%2).34!,,!4)/.7),,$!-!'%4(%().'%3#2%7!.$,/#+.54
s ,IFTLINEROUTOFOUTERSHELLBYLIFTINGUPONLINERLIPONBACKSIDEOFLINER
SEE&7HENREPLACINGLINERBESURETOPLIPOFLINERINSTALLSOVERTOPEDGEOF
outer shell (start with corners of lip and work in).
s#LEANASINDICATEDIN-AINTENANCEPAGE
s4OREASSEMBLEREVERSETHEPROCEDUREABOVE
B
C
E
F
Electrode
Left
side
slot
Radient Plate
Disconnect
wire
D
Screws
Battery