Instructions / Assembly

Table Of Contents

Attaching the light kit to

the switch housing

□ Remove the three light kit mounting screws (FF) from

the light kit (F) and keep these screws.

□ While holding the light kit (F) under your fan motor

assembly (B), locate two single white and blue wires

in the switch housing labeled "FOR LIGHT". Make the

polarized plug connections:

- White to white

- Blue to black

□ Carefully push all wires back into the switch housing.

Install the light kit (F) onto the switch housing with

the three light kit mounting screws (FF) provided. Be

sure to tighten all screws.

Installing the light bulb

and glass shade

CAUTION: Before starting installation, disconnect the

power by turning off the circuit breaker or removing the fuse

at the fuse box. Turning power off using the fan switch is not

sufcient to prevent electric shock.

□ Install 1 x 9W Medium base LED bulb (HH) (included).

□ Mount the glass shade (G) to the light kit (F) by

unscrewing partially the thumbscrews (GG) on the

light kit (F). Then insert the glass (G) and gently

tighten the thumbscrews (GG) by hand evenly to the

glass (G). Do not overtighten.

Assembly — Installing the Light Kit

NOTE: If you do not wish to install the light kit, skip steps 8

through 9 and proceed to step 10.

HOMEDEPOT.COM

Please contact 1-877-527-0313 for further assistance.