Datasheet

DATASHEET

Thermal Protector AC 250V/5A,DC 24V/10A

Version 08/16

Technical Specification Of BK05 Thermal Protector

1 Usage

BK05 thermal protector possess the benefits of miniature size、shell insulation、sensitive in action、

long life etc.Widely used in electric power points 、 electrical appliances 、 fluorescent ballasts 、

transformers、automobile motor、integrated circuit and general electric equipment of dual hot flow

protection function.

2 Appearance and structure：

Note: 200 ° c, heat-resistant material shell combustion level V

3 Property

3.1 Voted current(COS∮=0.7) DC24V-10A、AC250V-5A

3.2 Disconnect temperature: 30 ~ 155 °C ,reset temperature 20~ 110 °C(see "opening and reset temperature

drawing").

3.3 Ant-tension test: Product test pins should with no fault, sliding out when bearing ＞＝20N.

3.4 Insulation voltage:

PAGE 1
DATASHEET Thermal Protector AC 250V/5A,DC 24V/10A Version 08/16 Technical Specification Of BK05 Thermal Protector 1 Usage BK05 thermal protector possess the benefits of miniature size、shell insulation、sensitive in action、 long life etc.Widely used in electric power points 、 electrical appliances 、 fluorescent ballasts 、 transformers、automobile motor、integrated circuit and general electric equipment of dual hot flow protection function.
PAGE 2
a. Products in the lead when disconnect between AC660V shall withstand, 1min without breakdown flash over phenomenon; b. Product leads and insulated shell, between AC1800V can withstand 1S without breakdown flash over phenomenon.(striking current is 0.5mA) 3.5 Insulation resistance: under normal conditions, fuses and insulation shell insulation resistance in 100M Ω above. (used for DC500V meter) 3.6 Contact resistance:Product contact resistance shall not be more than 50mΩ。 3.
PAGE 3
5 Other items: 5.1 Disconnect the temperature detection heating rate should be controlled for 1 ° c / 1min, Use process cannot bear strong impact and stress. 5.2 Models of specifications BK05—— production specifications XXX℃—— voted disconnect temperature 6 This standard should separately conclude when not related to other matters or customer requirements. opening and reset temperature drawing NO. Disconnect Reset temp. NO. temp. Disconnect Reset temp. temp.