Full Product Manual

CBO-1000 Assembly Instructions

After you have built the Support Base and positioned the two Insulation Board

layers and Galvannealed Steel Plate as shown, you are ready to place the left

side of the Dome Assembly on the Insulation Boards, then join the right side

of the Dome Assembly. You have two Dome Assembly placement options:

• You can align the front of the Dome Assembly with the edge of the

Insulation Boards and your 2 1/2-inch Arch Assembly and Door will overhang.

• You can recess the Dome approximately 2 1/2 inches from the edge

of the

Insulation Boards to accommodate the Arch and Door Assembly.

Place the two “Wing” Hearth pieces inside the Dome.

The pieces should ﬁt snug against the walls of the Dome.

A Chicago Brick Oven wood burning oven is a custom-

manufactured product so some variances may occur, but

will not affect the performance of your Oven.

Finally, place the Center Hearth piece into position.

DO NOT DROP the Center Hearth piece into position.

The recommended approach is to gently slide the centerpiece

into position. Align the edges of the wing pieces to the edges

of the centerpiece. A Chicago Brick Oven wood burning oven

is a custom-manufactured product so some variances may

occur, but will not affect the performance of your Oven.

Place Insulating Blanket over the top of the Oven to create 3

inches of thickness. Cut out a hole for the Flue Pipe, and cut

the Insulating Blanket to line up with the front of the Oven. If

you have any extra insulation, put it on the top of the Oven.

Note: Industrial-grade aluminum foil may be placed over the

insulation for moisture protection.

Note: It is important that you use all of the insulation

supplied to avoid a possible ﬁre.

Attach the Steel Binding Plate to the back of the Dome

Assembly aligning the pre-drilled holes and included bolts.

Note: Do not over-torque bolts or you may dislodge the

threaded inserts!

Attach the Anchor Box to the Dome Assembly aligning the

pre-drilled holes and included bolts. Install the Anchor Box

before attaching the Insulating Blanket to the Oven.

Note: Do not over-torque bolts or you may dislodge the

threaded inserts!