Full Product Manual

2. Screw the inlet flange (with

suction pipe) into the tank

bung; seal threads liquid tight

with appropriate thread

sealant (Figure 2).

Typical Skid Tank Installation (cont’d)

Figure 2

3. Mount the pump on the

adapter; making sure

the seal and screen are

installed as shown.

(Figure 3).

Figure 3

CAUTION! DC powered pumps are designed to operate on either 12 or 24 VDC

(depending on model). Where applicable, use the supplied battery cable to

supply power to the pump from a 12 or 24 VDC battery. A 30 amp fuse (20 amp

fuse on 24 VDC motors) should be installed on the battery cable (see wiring

diagram page 9) to protect the wire in case of electrical short.

CAUTION! Voltage drop in wiring varies depending on the distance from the

battery to the pump and the gauge of the wire used. If the distance is greater

than 20’, refer to national, international, or local electrical codes to ensure the

wire is of the correct size for this application.

Electrical Wiring

DC Wiring Procedure

FR1200G / FR2400G / FR4200G / FR4400G / SD1202G Series DC Transfer Pumps